Latest activity
-
2aesthetic4me reacted to xargentum's post in the thread I8A0S Burble tune / not very aggressive? with
Like.
Hello, maybe you remember which table defines duration between pops? -
wheela reacted to ShocknAwe's post in the thread BimmerFab VS Jack Fabrication N54 Single Turbo Kit Questions with Like.
Why so much resistance to showing off what a quality product you have brought to market? To be clear the request was to see yours, not... -
wheela reacted to easy60's post in the thread BimmerFab VS Jack Fabrication N54 Single Turbo Kit Questions with Like.
I am definitely a prospective buyer, and I wouldn't be opposed to seeing the inside of the manifolds/collectors. Not really sure how...
-
Eeasy60 replied to the thread BimmerFab VS Jack Fabrication N54 Single Turbo Kit Questions.I am definitely a prospective buyer, and I wouldn't be opposed to seeing the inside of the manifolds/collectors. Not really sure how...
-
Dumaurier7 replied to the thread FS N55 Big Bore High Pressure Fuel Pump.BUMP! -
Eeasy60 reacted to SLOWESTN54's post in the thread BimmerFab VS Jack Fabrication N54 Single Turbo Kit Questions with Like.
Sheesh! This thread is some Good PR for Bimmerfab
-
Bimmerfab replied to the thread Forged Pistons in a Brand-New N54 Block – Measurements?.Kingtecs with my reccomened ring gap and hone. Been kicking pretty good for last 7500 miles. How long will they last ? As long as your... -
BBrule replied to the thread DIY Silent Twin Plate Clutch UniClutch.Wow! Thats worse than the motiv/spec twin plate I had. Ill have to look up 335d to see how other twinplates are on diesels but to me...
-
KKahnzill replied to the thread DIY Silent Twin Plate Clutch UniClutch.Using a TTV flywheel. Its a little bitey at low rpm and alot of vibrating goes thought the drive train at slower speeds or high gear...
-
CalvinNismo reacted to ShocknAwe's post in the thread BimmerFab VS Jack Fabrication N54 Single Turbo Kit Questions with Like.
Why so much resistance to showing off what a quality product you have brought to market? To be clear the request was to see yours, not... -
Aannyoing335i replied to the thread bad dme ? msd81.So i did just put my old dme back in to see if those code went away and they did the codes i got with the msd80 where the 30aa dme...
-
6ixInline replied to the thread Forged Pistons in a Brand-New N54 Block – Measurements?.Yes, the cylinder head has the same marks as well. -
ShocknAwe replied to the thread BimmerFab VS Jack Fabrication N54 Single Turbo Kit Questions.Why so much resistance to showing off what a quality product you have brought to market? To be clear the request was to see yours, not... -
wheela replied to the thread Forged Pistons in a Brand-New N54 Block – Measurements?.I agree, it does look like something got ingested. Does the cylinder head have marks like that too?
-
6ixInline replied to the thread Forged Pistons in a Brand-New N54 Block – Measurements?.It wasn't caused by the spark plugs. I also found these small metallic beads in the secondary cats, and they seem to be aluminum.
-
