X6M receiving some special treatment from Bimmer Performance Center

[phil@BPC]

We recently had this X6M arrive to have aftermarket downpipes wrapped and installed as long with our stage 2 tune flashed to the DME. These upgrades definitely back up this X6M's sinister looks.

For addition information feel free to reach out to us at [email protected] or (919) 501-2090

 

[nitemare]

We recently had this X6M arrive to have aftermarket downpipes wrapped and installed as long with our stage 2 tune flashed to the DME. These upgrades definitely back up this X6M's sinister looks.

For addition information feel free to reach out to us at [email protected] or (919) 501-2090


View attachment 21766

View attachment 21767

View attachment 21768

View attachment 21769

View attachment 21770

View attachment 21771

Phil whats the highest power you have seen or heard of yet on the N63TU, stock turbos? I'm getting an x550 soon and plan on: x5m filters or possibly custom made inlets, 97506 @ .024, catless downpipes, E30 mix, custom max effort tune (to include VANOS changes). It's going to be street tuned then cleaned up on the dyno. I seen someone made 530/575 with Stage 1 OTS BootMod3 only. I'm thinking with a little E30 mix, downpipes, and full on custom tune I don't see why 575-600whp is not obtainable. Would need N20 sensor swap I'm sure though.

 

[phil@BPC]

On our Stage 1 tune we see about a 127 WHP / 117 WTQ Gain over factory without downpipes and 93 octane. Based on stock numbers of 348 WHP / 397 WTQ this should put the vehicle around 475 WHP / 514 WTQ. We do offer stage 2 tunes for downpipes but I don't have the numbers on that tune yet. I do know it will be much higher than the Stage 1. At our shop we don't tune for E85 or other mixtures there is just too much headache with the lack of quality control at the gas stations in our area. Even with all that being said it could be possible to achieve numbers close to 575whp on stock turbos with meth. That will pretty much be maxing out the turbos at that point and testing the limits of other components such as connecting rods.

 

[nitemare]

Awesome thanks for the reply @phil@BPC . What's the target boost of the Stage 2 with DPs? I assume 21psi as that's the 2.5 TMAP limit.

 

[phil@BPC]

I really wish I knew the answer to those questions but unfortunately Im the photographer with limited knowledge and Id ask Bob our tuner but he gets really swamped towards the end of the week with tunes and updates. To better help you I would email bob directly at [email protected]. He would be better to ask these questions. Sorry i'm not much help