Tunerpro question

[JSR1256]

In tuner pro I set load target and load target AT at 210 across the board and the last two at 205, 200 but load target is still in the 180s on log and tapering to 14psi. Anyone have any input? I'd like target boost to be higher with little taper and allow it to taper on its own.

 

[Twisted Tuning]

In tuner pro I set load target and load target AT at 210 across the board and the last two at 205, 200 but load target is still in the 180s on log and tapering to 14psi. Anyone have any input? I'd like target boost to be higher with little taper and allow it to taper on its own.

make sure you dont have "Boost Target By Gear" or "Load Target By Gear" enabled

 

[JSR1256]

make sure you dont have "Boost Target By Gear" or "Load Target By Gear" enabled

I don't, here is the log http://www.datazap.me/u/itscoki/jr-v1?log=0&data=3-23

 

[V8bait]

Set "boost limit multiplier" in limits to 3 and "boost ceiling" under boost control to 1.5

 

[JSR1256]

Set "boost limit multiplier" in limits to 3 and "boost ceiling" under boost control to 1.5

Thank you sir! Will try

 

[JSR1256]

Thank you sir! Will try

Update, already been done. Do you mind if I send u the bin to glance over and see if anything is off? No rush if you do, I know you're a busy tuner. My email is [email protected] if you wanna shoot me a email so I can send it. Thanks

Set "boost limit multiplier" in limits to 3 and "boost ceiling" under boost control to 1.5