135i tire rubbing fender issue

[Dirty135]

I have a 135i on st xta coil overs. Running apex arc 8 with 265 tires. Rubbing like a mf in the rear.

Anybody have any tips on cutting off the inner fender lip?

 

[SlowE93]

I have a 135i on st xta coil overs. Running apex arc 8 with 265 tires. Rubbing like a mf in the rear.

Anybody have any tips on cutting off the inner fender lip?

Grinder with sanding disc. Be VERY careful and coat the inside after so it doesn't rust.

 

[ShocknAwe]

Have you rolled it flat yet? I don't recommend cutting anything other than the tabs.

 

[oVeRdOsE]

with the wear on the tire, this is not the fender liner.

Use a roller, 40-50$ on amazon.

Did mine not so long ago. I was running 265 on style193M and 10mm spacers.

all good now

 

[Dirty135]

with the wear on the tire, this is not the fender liner.

Use a roller, 40-50$ on amazon.

Did mine not so long ago. I was running 265 on style193M and 10mm spacers.

all good now

The fenders are rolled already and flattened inside. I took the spacers out. Running no spacers. Not sure why they even put them on. It doesn’t run now lol. Can probably go wider.

Is there a reason the rears need spacers with apex arc 8 and st coil overs

 

[ShocknAwe]

The fenders are rolled already and flattened inside. I took the spacers out. Running no spacers. Not sure why they even put them on. It doesn’t run now lol. Can probably go wider.

Is there a reason the rears need spacers with apex arc 8 and st coil overs

If the offset is the old +62mm it may rub the fuel filler neck if the tire is wide enough, 5mm spacer eliminates this.