load

First post so hello everyone Ive been studying mevd and mg1 bosch on bmw trying to understand how this all works but I am lost on one area. I understand the ecu's are torque based and using diop table torque is converted to load and at some point the table is used in reverse to calculate back...

Hi I had some time to play around with this "new" boost target xdf which I have attached. I am running a rescaled N20 tmap sensor tune at 155 load. First I did a run with values set to 1.0 This is a log with this tune: Datalog Then I changed the values at 5000 and 6000 rpm like in the...